The process of making a human hair wig(二)

Due to the length of the relationship, in the last chapter, we did not fully introduce the production process of human hair wig, only introduced the preparatory work of cutting, whole hair, pound hair, hair discharge, etc., then today we will The fifth process begins with a detailed introduction to the production process of human hair wig.

The fifth process: interception

The hair after the hair is very long, the whole hair of the car must be divided into the required length is the cut, and the length of each strip can not exceed the length of the bar, this process is relatively simple. You need to cut the hair according to the specific size you need. The size of the straight hair wig is different from the size of the bob lace wig. One of them is long hair, and the other is short hair. You need to be careful not to put their hair together for cropping.

The sixth process: washing water

Cut the hair, absorb the nutrients through the washing water. The seventh process:

Inserting and pressing three pits

After the dry and dry, the hairpiece should be inserted and pressed to make the most original shape.

Insertion: The main role is to increase the bulkiness of the hair, usually concentrated in the bangs and the top of the head. Good human hair wigs are full of heads, very type, not pointed, sticking to the scalp, this is the merit of the two processes of inserting and pressing the three pits. Generally, the production of low-priced wig factories will save these two processes to save production costs.

The eighth process: curly hair

According to the curvature of the wing design, different sizes of tubes are used.

The ninth process: baking

I am often asked: curly hair, do you not wear it twice? Look carefully below and you will know the answer. According to the requirements of the drawings, the split springs are placed in a suitable curvature bar, placed in an oven, and set at a constant temperature of 88 degrees Celsius.

After baking for 2 hours, the hair is removed and then unsealed, so that the hair is not easy. Distorted. After the roll is completed, part of the raw material is transferred to the high car process, and the other part is placed in the scalping process.

Note: Different materials, different seasons and weather will have an effect on the temperature of the oven. It is technically difficult to determine the temperature.

The tenth process: straight bang crater

Do a crater on the straight bang clockwork to prevent the straight bang from sticking to the forehead and causing the shape. The eleventh process: high car

The high car is to sew the baked wig piece on the human hair wigs. For high-quality wigs, this process is more complicated and requires a lot of technicians. A skilled worker can only drive 30 to 40 cars a day. The same workers can produce more than 100 tops a day if they have a low-quality wig.

If you are only interested in these, you can then follow our “ the process of making a human hair wig (三)”, I believe it will not let you down.